Description
Application
The TLBE heating sections are applied as a basic heating system in thermally insulated buildings when it is impossible to use a central heating system. These systems are excellently applicable for installation in screeded floors and can be used under any covering of your choice: tile, marble or carpet.
Construction
The double-core heating section TLBE consists of a shielded heating cable with two cores, one coupling, one cold lead and a cable termination. Due to the double-core design of the heating cable, the electric power is supplied from one end of the section which makes the installation process easier. The TLBE heating sections are used in combination with thermostats. Therefore the consuming power of the system will be less than the installed power (up to 70% in winter and about 10% in spring and in autumn).
Features
- Maximum cost and energy saving
- Wide range of heating cable power outputs
- Wide range of application possibilities
- Long-life performance
- Easy handling
Installation
For uniform heat distribution, the heating sections are installed in loops with constant spacing by using the assembly tape. For the installation of the heating section an additional thermostat with an appropriate temperature sensor is required. The temperature sensor is embedded in the cement mortar. It should be placed in a corrugated tube in the middle of one cable loop. The thermostat should be mounted on the wall in the most suitable place for you. Applicable norms, rules and data sheets as well as instructions and manuals are to be followed! For detailed installation instructions please use the installation manual.
Technical Data
| Rated voltage | 230 VAC |
|---|---|
| Power | 16–18 W/m |
| Maximum operation temperature | 80 °C |
| Minimum operation temperature | –10 °C |
| Minimum storage temperature | –20 °C |
| Minimum installation temperature | –10 °C |
| Minimum bending radius | 30 mm |
| Cold lead length | 3 m |
| Cable diameter | 5,5×7,9 mm |
Reviews
There are no reviews yet.