Description
Application
The spooled GB heating sections are applied as a supplementary system for comfortable floor heating. In thermal insulated buildings the GB heating sections could be used as a basic heating system when it is impossible to use a central heating system. The ultra-thin GB heating sections are excellently applicable for the installation in a tile adhesive layer or in screed. They can be applied under any covering of your choice: tile, marble or carpet.
Construction
The double-core heating section GB consists of a heating cable with two cores in a foil-coated screening sheath with a protective drainage wire, one coupling, one cold lead (3 m length) and a cable termination. Due to the double-core design of the heating cable, the electric power is supplied only from one end of the section, which makes the installation process easier. The cable insulation is made of tough heat-resisting non-flammable fluoropolymer. The cable shield is made of aluminium foil, reinforced with a copper line. The GB heating sections are made exclusively of high quality materials produced by world leading manufacturers. The GB heating sections operate in combination with thermostats. Therefore the consuming power of the system will be less than the installed power (up to 70%).
Features
- Small cable diameter
- Ecological compatibility
- 100% guarantee of electrical safety
- 100% absence of electromagnetic radiation
- Additional protection against overheating
- Universal solution for premises with complex room layouts
- Maximum cost and energy saving
- Easy installation
Installation
For the installation of the heating cable section an additional thermostat with an appropriate temperature sensor is required. The temperature sensor is also embedded in the cement mortar. It should be placed in a corrugated tube in the middle of one cable loop. The thermostat should be mounted on the wall in the most suitable place for you. Applicable norms, rules and data sheets as well as instructions and manuals are to be followed! For detailed installation instructions please use the installation manual.
Technical Data
| Rated voltage | 230 VAC |
|---|---|
| Power | 12 W/m |
| Maximum operation temperature | 90 °C |
| Minimum operation temperature | –10 °C |
| Minimum storage temperature | –20 °C |
| Minimum installation temperature | –10 °C |
| Minimum bending radius | 30 mm |
| Cold lead length | 3 m |
| Cable diameter | 3,78–5,05 mm |
Reviews
There are no reviews yet.